Komatsu — PANEL GAUGES, INDICATORS, AND CONTROLS (Figure 3-6)

OM3035.3 02/03 Operation - Section 3 Instrument Panel & Indicator Lights Page 3-25 (2, Figure 3-6) ENGINE SHUTDOWN SWITCH with TIMER DELAY This is a 3-position rocker-type switch (Off-On-Momentary). Refer to "Operating Instructions" section, "DELAYED ENGINE SHUTDOWN PROCEDURE", for a complete detailed operation of this switch. 1. Press top of switch to the “On” (center position), then press firmly to the “Momentary” (upper position) and hold this position briefly to activate the 5 Minute Idle Timer (switch is spring-loaded to return to “On” position when released). 2.

When the Engine Shutdown Timer has been activated, the Timer Delay indicator light in the overhead display panel (C4, Figure 3-7) will illuminate to indicate that the shutdown timing sequence has been started. The engine will continue to run at Idle RPM for approx- imately 5 minutes to allow for proper engine cool-down before stopping. 3. The Engine Shutdown Timer switch DOES NOT turn off 24 VDC electric power. Turn Key- switch counterclockwise to the “Off” position to cause the engine to shutdown when timing sequence is complete.

When the engine stops after the 5 minute idle period, the hydrau- lic bleeddown timer will be activated and turn off the 24 VDC electric circuits controlled by the keyswitch. Engine WILL NOT SHUT DOWN, if keyswitch is not turned to the “Off “ position. NOTE: To cancel the 5 Minute Idle Timer sequence, press Timer Delay Shutdown switch to the “Off” (lower) position. • If keyswitch is in “Off” position, engine will stop. • If keyswitch is in “On” position, engine will continue to run. If engine does not shutdown with keyswitch, use Engine Shutdown Switch on operator cab center console, and hold this switch down until engine stops.

The Ground Level Shutdown Switch will also stop the engine during this time-out. (3, Figure 3-6) FOG LIGHTS (OPTIONAL) Fog Lights are optional equipment that are useful in foggy conditions and heavy rain. Pressing the top of the rocker switch turns the lights "On". Pressing the bottom of the switch turns the lights "Off". (4, Figure 3-6) LADDER LIGHT SWITCH The switch turns the ladder lights "On" or "Off" after or before using ladder. Pressing the top of the rocker switch turns the lights "On". Pressing the bottom of the switch turns the lights "Off". Another switch is mounted at the front left of truck near the base of ladder. y i in n x ” s - y- g u- y