Operation - Section 3 OM3035.3 02/03 Page 3-24 Instrument Panel & Indicator Lights FIGURE 3-6. PANEL, GAUGES, INDICATORS, AND CONTROLS 1. Keyswitch 2. Engine Shutdown Switch with Timer Delay 3. Fog Light Switch (N./O.) ( Optional ) 4. Ladder Light Switch 5. Backup Light Switch (N./O.) 6. Panel Illumination Light(s) 7. Vent(s) - Cab Air Conditioner / Heater 8. Engine Starting Aid Switch (N./O.) ( Optional ) 9. Rotating Beacon Light Switch (N./O.) ( Optional ) 10. Heated Mirror Switch (N./O.) ( Optional ) 11. Leakage Test Switch ( Trolley Option ) 12. Wheel Brake Lock Switch (N./O.) 13. Parking Brake Switch (N./O.) 14. Digital Tachometer 15. Right Turn Signal Indicator Light 16.
High Beam Headlight Indicator Light 17. Left Turn Signal Indicator Light 18. Digital Speedometer / Payload Meter Displa 19. Voltmeter Gauge 20. Engine Oil Pressure Gauge 21. Engine Water Temperature Gauge 22. Fuel Gauge 23. Blank - Not Used In This Application 24. Engine Hourmeter 25. Blank - Not Used In This Application 26. Blank - Not Used In This Application 27. Headlights Switch (N./O.) 28. Wiper / Washer Switch 29. Panel Illumination Lights Dimmer Rheostat 30. Payload Meter Switch PANEL GAUGES, INDICATORS, AND CONTROLS (Figure 3-6) (1, Figure 3-6) KEY SWITCH The keyswitch is a 3-position (Off, Run, Start) switch.
When switch is rotated one position clockwise, it is in the "Run" position and all electrical circuits (except "Start") are activated. With Selector Switch in "Neu- tral", rotate keyswitch fully clockwise to "Start" posi- tion and hold this position until engine starts. "Start" position is spring loaded to return to "Run" when key is released. With truck stopped, turn keyswitch coun- terclockwise to "Off" for normal engine shutdown. Use Engine Shutdown switch on center console if engine does not shutdown with keyswitch. NOTE: A ground level shutdown switch is located on lower front left side of truck.