Komatsu — DETERMINING "FAULT" CODES

Operation - Section 3 OM3035.3 02/03 Page 3-38 Instrument Panel & Indicator Lights CENTRY™ FUEL SYSTEM DIAGNOSTICS If the truck is equipped with a Komatsu engine and Centry™ Fuel Control system, the SERVICE ENGINE Indicator Light (D6, Figure 3-7) monitors the Centry™ fuel system. When the keyswitch is turned "On", this light should illuminate for about 2 seconds and then turn "Off", if no "faults" are detected in the system. If the light stays ON, or FLASHES, then active "faults" have been detected by the system and the engine should not be started. Refer to DETERMINING "FAULT" CODES below.

During engine operation, if a "fault" is detected in the system, the light will turn ON and stay on for "Warn- ing faults", or it will turn "ON and FLASH" for more severe faults that can affect engine operation and require immediate attention. "Warning" faults (light ON) are ones that require attention in the near future, but in most conditions will not greatly affect governing performance. "Severe" faults (light FLASHING) are ones that require immediate attention, because Centry™ governor performance could be significantly affected, resulting in a backup mode of operation. Active fault conditions MUST be corrected as soon as possible.

The Lamp Test/Diagnostic Test Switch (10, Figure 3- 7) may be used to activate the Centry™ Fuel System diagnostic codes. When the Centry™ fuel system detects a "fault" and the SERVICE ENGINE indicator light (D6, Figure 3-7) illuminates as described above, this switch will permit determination of the kind of "fault(s)" detected. DETERMINING "FAULT" CODES Centry™ fault codes consist of three numerical dig- its. Each digit is indicated with up to five light flashes (SERVICE ENGINE indicator light) per each digit. There is a short pause between each digit of the fault code. Once all three digits are flashed, there is a longer pause, followed by a repeating of the same fault code sequence. 1.

To determine an active Centry™ "fault", turn the keyswitch to the OFF position. Be sure engine completely stops, if it was running.