Komatsu — EXITING THE DIAGNOSTICS MODE

OM3035.3 02/03 Operation - Section 3 Instrument Panel & Indicator Lights Page 3-39 2. Turn keyswitch to ON position (engine not run- ning) and press Lamp Test switch to the bottom (" " position) for 1 - 2 seconds, then release (switch is spring-loaded to the top, "OFF" posi- tion). NOTE: Since this is the Lamp Test switch, all red warning lights and amber indicator lights should light up except those that are "BLANK". The warning horn will also sound. 3. If there is an active fault after releasing the switch, there will be a short pause, followed by the first fault code. 4.

Pressing the Lamp Test switch to the bottom (" ") again will advance to the next fault code (if more than one code is present). Once all active fault codes have been displayed, the fault code display sequence will be repeated, starting from the first fault code. EXITING THE DIAGNOSTICS MODE Starting the engine or turning the keyswitch to the OFF position will EXIT the diagnostics fault flash mode. If active fault codes have been determined as described previously, refer to the Cummins Centry™ System "Troubleshooting and Repair Manual", Bulle- tin No. 3666070, or contact an Authorized Repair Location.