. MAINTENANCE MAINTENANCE PROCEDURE check that oil oozes out from port S hose (3). NOTICE Do not operate the swing under any circumstances. 2) If oil does not ooze out, stop the engine, remove port S left and right. This will 4 - 44 BLEEDING AIR FROM HYDR AULIC SYSTEM For details, see "STARTING EN GINE (PAGE 3-88)". If it is necessary to refer to the item s for starting the engine, moving the machine off, steering , or stopping, see the OPERATION section. check that oil oozes out from the e the drain hose from the pump il through drain port (2) to fill the the drain hose is removed, so ece at a position higher than the aulic tank. eed operation, tighten air bleeder ose. 1.
Bleeding air from pump 1) Loosen air bleeder (1) and air bleeder. 2) If no oil oozes out, remov case, and add hydraulic o pump case. Oil will come out when secure the hose mouthpi level of the oil in the hydr 3) After completing the air bl (1) and install the drain h 1. Bleeding air from pump 1) Loosen air bleeder (1) and check that oil oozes out from the e the drain hose from the pump il through drain port (2) to fill the the drain hose is removed, so ece at a position higher than the aulic tank. 3) After completing the air bl eed operation, tighten air bleeder NOTICE will spurt out from bleeder hole (1).
If the drain hose is installed first, oil If the pump is operated without filling the pump case with hydraulic oil, abnormal heat will be gener ated and this may cause an unexpected damage to the pump. 2. Starting engine Start the engine, referring to Run the engine at low idle for 3. Bleeding air from cylinders 1) Run the engine at low idl not moved to the end of i 2) Next, operate each cylind 3) Finally, operate each cyli 1) Run the engine at low idl e, and extend and retract each cylinder 4 to 5 times, tak ing care that a cylinder is ts stroke. (Stop the cylinder approx. 100 mm (3.9 in) sh ort of its stroke end) emove the air.
2) Next, operate each cylind er 3 to 4 times to the end of its stroke. 3) Finally, operate each cyli nder 4 to 5 times to the end of its stroke to completely r NOTICE If the engine is run at high speed imm ediately after startup or a cylinder is pushed up to its stroke end, air taken inside the cylinder may cause damage to the piston pac king. 4. Bleeding air from swing moto r 1) Run the engine at low idli ng, loosen hose (3) at port S, and hose (3) and elbow (4), th with hydraulic oil. 3) After completely bleeding the air from the swing motor, install elbow (4), then tigh 4) Run the engine at low id le and slowly swing at least two times uniformly to th ir from the swing circuit.
automatically bleed the a