Komatsu — WHEN REQUIRED

. MAINTENANCE MAINTENANCE PROCEDURE from 4 - 45 NOTICE If the air is no t bled from the s wing motor, th e motor bear ings ma y be da When replaci ng the travel mot or safety valve, please cont act your Koma tsu distributor to have i t replaced and to have t he air bled. 5. Bleeding a ir from travel m (Bleed the air only when the oil inside the travel motor case ha 1) Run the engine at low idling, loosen air bleeder (5), and tighten it when oil flows out. (Bleed the air only when t he oil inside t he travel m otor case ha 1) Run th e engine at lo tighten it when oil flow 2) Run th e engine at low idle and swing the wor 90° to bring it to the si de of the track.

3) Jack u p the machine until the trac k is the gro und. Rotate th e track under no load for Repea t this procedure on both the left and rig ht sides 6. Bleeding a ir from attachm ent (when installed) I f a breake r or other attach ment has been i nstalled , run th e engi ne at low idle and ope rate the attachment p eda repeatedly (approx. 10 tim es) until the air has bee n bled f rom t he attachment circuit . NOTICE If the method of bleeding the air from the attachment its elf is specified by the manufacturer, b leed the air according t o the specified pro cedure.

After complet ing the air bleedi ng operation, s top the engi ne, and leave t he machine for 5 minute s before starting operations. This will rem ove the air bubble s in the oil inside the hydr aulic cylinders. Chec k that th ere is no leakage of oil and wip e of f any oil that has been s After complet ing the air bleedi ng operation, i nspect the o il level, a nd if t he oil level is low, add o