. MAINTENANCE MAINTENANCE PROCEDURE 10. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. not to let water get on the (5), dry it completely before 14. Turn the valve (1) at the bottom of the fuel tank to the OPEN position (O). 15. After completing the replacement of filter cartridge (4), bleed the air. 18. After finishing to bleed air, push in the knob of feed pump (7) and tighten it. 4 - 56 9.
When installing, apply oil to th e packing surface and bring the packing surface into cont act with the seal su of filter cartridge (4) and then If the transparent cap is tighte is not tightened enough, fuel securely to the fixed tightenin tighten it further by 1/4 - 1/2 turns. ned too much, the O-ring will be damaged and this will c ause leakage of fue will leak through the gap at the O-ring. To prevent these p roblems, always tig g angle. NOTICE When adding fuel, do not remove small holes (A) on the dirty side. After adding fuel, remove cap (B) a Always fill with clean fuel. Be care the fuel. In particular, center portio cap (B) when adding fuel. Be carefu portion on the clean side. 11.
When installing, tighten until t he packing surface contacts the seal surface of the filter h older, then tighten of a turn. If the filter cartridge is tighten filter cartridge is too loose, fu When tightening with a filte ed too far, the packing will be damaged and this will lead to leakage of fuel. el will also leak from the packing, so always tighten the c r wrench, be extremely careful not to dent or damage th 12. Check that the drain valve (2) 13. Remove the vinyl bag coverin REMARK If water gets on the connector and the water separator monit connector (5), be extremely c connector. If water gets on connector connecting it. Bleed the air as follows:
full (to FULL mark on the fuel gauge). 16. Add fuel to the fuel tank until 17. Loosen the knob of feed pum p (7), pull it out, then pump it in and out until the movem ent becomes heavy REMARK It is not necessary to remove t he plug at the top of the fuel pre-filter and fuel main filter After the engine runs out of fu el, use the same procedure to operate feed pump (7) an