Komatsu — EVERY 500 HOURS MAINTENANCE

. MAINTENANCE MAINTENANCE PROCEDURE CLEAN AND INSPECT RADIATOR FINS, OIL COOLER FINS, AFTERCOOLER FINS, FUEL COOLER FINS, AND AIR CONDITIONER CONDENSER FINS (only machines equipped with air conditioner) WARNING NOTICE 4 - 58 If compressed air, high-pressure water , or steam hits your body directly or dirt is sent flying by the co mpressed air, high-pressure wate r, or steam, there is danger of per sonal injury. Always wear protective glasses, dust mask, and other protective equipment. Whe n using compressed air for cleanin g, blow it keeping some distance to avoid damaging the fins. D amage on the fins can cause wate r leakage and overheating.

In a d usty job site, check the fins ever y day, regardless of the maint 1. Open the engine hood. 2. Loosen screws (1) (located at 4 spots) to pull up each of n ets (2), (3). nets (2), (3). 3. After pulling up, clean each of 4. Check the front and rear surfa fins (5), aftercooler fins (6), ces of radiator fins (4), oil cooler fuel cooler fins (7), and air l conditioner condenser fins (8 ). If there is any mud, dirt, or eaves stuck to the fins, blow the dirt off with compressed air. Steam or water may be us However, when carrying o ed instead of compressed air.

ut powerful steam cleaning sh) of the heat exchange er, aftercooler, fuel cooler, air (high-pressure machine wa equipment (radiator, oil cool conditioner condenser), main air tain sufficient distance from the e operation. If steam cleaning ) is carried out at close range, rnal fins of the heat exchange the machine when carrying out th (high-pressure machine wash there is danger that the inte 5. equipment may be deformed, and breakage. Check the rubber hose. Repl and this will cause early clogging ace with a new one if the hose is found to have cracks or to be hardened by aging. In addition, check the hose clamps for loo seness. f nets (2), (3) into the original with screws (1). 6.

After cleaning, insert each o position and then fasten them