. MAINTENANCE MAINTENANCE PROCEDURE REPLACE HYDRAULIC OIL FILTER ELEMENT WARNING cause burns. Wait for the 12. Check for oil leakage and wipe off any spilled oil. 4 - 66 The parts and oil are at hi gh temperature immediately after the engine is stopped, and may ore starting the work. cap, turn it slowly to release the internal pressure, then remove it. temperature to go down bef When removing the oil filler cap, turn it slowly to release the inte NOTICE f the machine is equipped wit h a hydraulic breaker, the hydraulic oil will deteriorate much faster than during normal bucket operations. For details, see maintenance.
"MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out 1. Set the work equipme nt on the hard and flat ground i n the maintenanceposture as ground and stop the en shown in the figure, then lower it to the gine. 2. Remove the cap from pressure. 3. Loosen 6 bolts, then re oil filler (F), and release the internal move cover (1). When doing this, the er the force of spring (2), so hold the ving the bolts. 2), valve (3) and strainer (4), take out ternal cover may fly out und cover down when remo 4. After removing spring ( element (5). Inspect the bottom of any. Take good car hydraulic tank.
the filter case for dirt, and remov e it, if e then not to let fall the dirt into the ts in flushing oil. 5. Clean the removed par 6. Install the new element in the place where old element (5 ) was installed. 7. Set valve (3), strainer ( 4) and spring (2) on top of the ele ment. 8. Set cover (1) in position , push it down by hand, and inst all the cover with the mountin g bolts. p and install the cover. the engine according to "STARTING 9. Screw in the oil filler ca 10. To bleed the air, start ENGINE (PAGE 3-88)" minutes. 11. Stop the engine. and run the engine at low idle for 10 REMARK Operate the machine after halting for more than 5 minutes t o eliminate bubbles in the oil