. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE out, then pump it in and out until the movement becomes heavy. REMARK at the top of the fuel same procedure to 4 - 65 Replace inner s NOTICE filter cartridge with fuel. Do not fill the new Remove cap (B) a nd install the filter cartridge. 6. When installing , tighten until the packing surface contacts the seal surface of the filter holder, then tighten it 3/4 of a turn. If the filter cartr idge is tightened too far, t he packing will be damaged and this will lead to leakage of fuel. If the filter cartridge i s too loose, fuel will also leak from the packing, so always tighten the c orrect amount. 7.
Turn the valve (1) at the bottom of the fu el tank to the OPEN position (O). r cartridge (2), bleed the air. 8. After completin g the replacement of filte Bleed the air as fol 9. Fill the fuel tan k with fuel (to the position 10. Loosen the kn ob of feed pump (4), pull pre-filter and fu After the engin operate feed pu mp (4) and bleed the air. 11. Push in the kn ob of feed pump (4) and t 12. After replacing the filter cartridge, start t he engine and run it at low idling for 10 minut Check for leak age of oil from the filter sea l surface. If any oil is leaking, check the tighte ning of the filter cartridge.
If there is still oil leakage, repeat Steps 1 - 4 to remove the filter cartridge, and if an y damage or embedded foreign materia l in the packing surface is found, replace it with a new cartridge and rep eat Steps 5 - 12 to install it.