hyundai — 3. ELECTRICAL SYSTEM

GROUP 3 ELECTRICAL SYSTEM 1. WHEN STARTING SWITCH IS TURNED ON, MONITOR PANEL DISPLAY DOES NOT APPEAR 余 Before disconnecting the connector, always turn the starting switch OFF. 余 Before carrying out below procedure, check all the related connectors are properly inserted and short of fuse No.7. 余 After checking, insert the disconnected connectors again immediately unless otherwise specified. Check voltage CLUSTER FUSE POWER IG(24V) 1 3 No.7 GND RX 3 2 10 9 TX 4 11 CN-56 CN-5 21076ES51 6-24 YES Check voltage YES between CN-56 (1) and chassis NO Check voltage between CN-5 (3) and chassis Starting switch : ON Voltage :

20~32V NO Cause Remedy Defective clucter Disconnection in wiring harness or poor contact between CN-5 (3) -CN-56 (1) Disconnection in wiring harness or poor contact between CN-5 (3) and fuse No.7 Replace Repair or replace (After clean) Repair or replace (After clean) YES 2 0 ~ 32V NO 0V