hyundai — 3. ELECTRICAL SYSTEM

2. COMMUNICATION ERROR "Co : Er" FLASHES ON THE CLUSTER 余 Before disconnecting the connector, always turn the starting switch OFF. 余 Before carrying out below procedure, check all the related connectors are properly inserted. 余 After checking, insert the disconnected connectors again immediately unless otherwise specified. Check voltage MCU YES *4V *12V 30 SERIAL-RX 29 SERIAL-TX CN-50 CLUSTER POWER IG(24V) 1 3 FUSE GND *12V 2 9 No.7 TX RX *4V 4 3 11 10 CN-56 CN-5 29076ES02 6-25 YES Check voltage YES between CN-56 (3,4) and chassis NO Check voltage between CN-5 (10,11) and chassis Starting switch :

ON NO Cause Remedy Defective controller Disconnection in wiring harness or poor contact between CN-56 (3,4)-CN-5 (10,11) Disconnection in wiring harness or poor contact between CN-5 (10,11)-CN-50 (29,30) Replace Repair or replace (After clean) Repair or replace (After clean) NO 0V 0V