Komatsu — CONTROLS ON RADIO

OPERATION Remark With each mode, the display is returned automatically to its original setting after 5 seconds. SETTING CORRECT TIME 1. Press display selector button (4) to display the time. After 5 seconds, the display will return to the frequency display and the time cannot be corrected. If this happens, press display selector button (4) again. 2. Press time adjustment button (8) to set to Hour or Minute. H button: Adjusts the hour (each time the button is pressed, the time advances by one hour) M button:

Adjusts the minute (each time the button is pressed, the time advances by one minute) If the H or M button is kept pressed, the time will advance continuously until the button is released. ADJ button: When the ADJ button is pressed, the time is reset as follows. When display is 00 - 05 minutes, time is returned to 00 min. 00 sec. (No change in hour) When display is 55 - 59 minutes, time is advanced to 00 min. 00 sec. (Hour advances) When display is 06 - 54 minutes, time cannot be reset. (Time stays same) Example -10:05 10:00 -10:59 11:00 -10:26 10:26 Use the H , M , and ADJ. buttons to set to the correct time.

ANTENNA Before transporting the machine putting it inside a building, stored the antenna to prevent any interference. Stow the antenna as follows. 1. Loosen antenna mounting bolt(1)and store the antenna at position). 2. Tighten bolt(1). USE RADIO WITH CARE To ensure safety, always keep the sound to a level where it is possible to hear outside sounds during operation. If water gets into the speaker case or radio, it may lead to an unexpected failure, so be careful not to get water on the equipment. Do not wipe the scales or buttons with benzene, thinner, or any other solvent. Wipe with a soft dry cloth. Use a cloth soaked in alcohol if the equipment is extremely dirty.

When the battery is disconnected or replaced, settings for the preset buttons and clock are cleared, so all settings must be reprogrammed. 2-66 PC400LC-7E0