Komatsu — CONTROLS ON RADIO

OPERATION . CONTROLS ON RADIO PRESET STATION BUTTONS 1. Press power switch (1) and display the frequency on display (7). 2. Use tuning button (9) to set to the desired frequency. There are two methods for tuning: auto tuning and manual tuning. 3. With the display (7) showing the desired frequency, keep the desired Preset button No pressed for at least 1.5 seconds. The reception sound will disappear, but when the presetting operation (saving to memory) is completed, the sound will appear again and the Preset No and frequency will be shown on the display to show that the presetting operation has been completed.

After completing the presetting, press Preset button (6) and release it within approx. 1.5 seconds. This will make it possible to receive the channel preset to that button. One channel each for AM and FM can be preset to each Preset button. Remark It is also possible to save to the Preset button by using the auto store button. SETTING WITH PRESET BUTTON 1. Press power switch (1) and display the frequency on display (7). 2. Use tuning button (9) to set to the desired frequency. There are two methods for tuning: auto tuning and manual tuning. Manual Tuning Press tuning button (9) until the frequency is displayed on display (7). > button: Frequency moves up Bottom Top.

When the frequency reaches the top or bottom frequency, it automatically continues as follows: Top Bottom, or Auto Tuning Press tuning button (9) for at least 3 seconds. When a station is picked up, the tuning automatically stops. To search for the next station, press the tuning button again for at least 3 seconds. > button: Frequency moves up If this button is pressed during auto tuning, the auto tuning will be cancelled and the setting will return to the frequency in use before the button was pressed. OPERATING MODE PC400LC-7E0 2-65 (BAS) Bass adjustment button: When button (2) is pressed, BAS is displayed on display (7).

If knob (1) is turned clockwise within 5 seconds, the bass sound is emphasized. If the knob is turned counterclockwise, the bass sound is reduced. (TRE) Treble adjustment button: When button (2) pressed, TRE is displayed on display (7). If knob (1) is turned clockwise within 5 seconds, the treble sound is emphasized. If the knob is turned counterclockwise, the treble sound is reduced. (BAL) Balance adjustment button: When button (2) is pressed, BAL is displayed on display (7). If knob (1) is turned clockwise within 5 seconds, the sound from the right speaker is increased. If the knob is turned counterclockwise, the sound from the left speaker is increased.

When it is set to BAL 0, the sound from the left and right speakers is balanced.