Komatsu — CHECKS BEFORE STARTING

OPERATION CHECK AND DRAIN WATER SEPARATOR 1. Open the front engine hood of the machine. 2. The water separator forms one unit with fuel pre-filter (1). 3. It is possible to judge the water level and amount of sediment by looking through transparent cap (2). If there is any water or sediment collected at the bottom, set a container to catch the drain water under drain hose (3). 4. Loosen drain valve (4) and drain the water. 5. When fuel starts to drain from drain hose (3), tighten drain valve (4) immediately. CHECK AND ADD ENGINE OIL Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns.

Wait for the oil temperature to go down before checking oil. 1. Open the engine hood on the machine. 2. Remove dipstick (G), and wipe the oil off with a cloth. 3. Fully insert dipstick (G) into filler pipe (F), then remove it. 4. The oil level should be between the (H) and (L) marks on dipstick (G). If the oil level is below the (L) mark, add oil through oil filler (F). PC400LC-7E0 2-73