OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE Emergency stop If there has been any abnormal actuation or trouble, turn the starting switch key to the OFF position. Do not carry out operations or operate the levers or pedals suddenly while the hydraulic oil is at low temperature. Always carry out the warming-up operation for the hydraulic equipment until the hydrau- lic oil temperature monitor is displayed green. If the warming-up operation for the hydraulic equipment is not carried out thoroughly, and the machine is moved, the reaction of the control levers and pedals will be slow and the movement may not be what the operator intended. Always warm up the hydraulic equipment.
In particular, in cold areas, always warm up the hydraulic equipment thoroughly If any problems occur, turn the ignition switch to the “OFF” position. If the work equipment is operated without warming up the machine sufficiently, the response of the work equipment to the movement of the control lever will be slow, and the work equipment may not move as the operator desires, so always perform the warm-up operation. Particularly in cold areas, be sure to perform the warm-up operation fully. BREAKING IN THE MACHINE Your Komatsu machine has been thoroughly adjusted and tested before shipment.
However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the machine life. Be sure to break-in the machine for the initial 100 hours (as indicated by the service meter). During break-in operations, follow the precautions described in this manual. Idle the engine for 5 minutes after starting it up. Avoid operation with heavy loads or at high speeds. There are two types of warming-up operation: warming up the engine and warming up the hydraulic equipment.
In addition, depending on the environment, the method of carrying out the warming-up operation may differ, so carry out the warming-up operation according to the items given in the appropriate section. Avoid sudden starts, sudden acceleration, sudden steering and sudden stops except in cases of emergency. When only the engine is warmed up, the hydraulic equipment is not warmed up, so always carry out the warming-up operation for the hydraulic equipment separately from the warming-up operation for the engine. Warming up the hydraulic equipment thoroughly ensures that the hydraulic oil is warmed up and that warm hydraulic oil circulates in all the control circuits.
WARMING UP ENGINE Do not accelerate the engine suddenly until the warming-up operation has been completed. Do not run the engine at low idling or high idling under no load for more than 20 minutes. This will have an adverse effect on the environment, and will also have an adverse effect on the internal structure of the engine. If it is necessary to run the engine at idling for more than 20 minutes, apply a load from time to time or run at a mid-range speed. After the engine starts, do not start operating the machine immediately. First, carry out the following operations and checks. PC400LC-7E0 2-85