OPERATION 1. Swing the upper structure so that the work equipment is at the sprocket end (1). 2. Extend the bucket cylinder and arm cylinder fully, then lower the work equipment to the ground as shown using the boom cylinder. 3. Set the lock lever securely in the LOCK position (L) 4. Stop the engine, check to be sure there is nothing around the oper- ator's compartment, then get off the machine. Close the cab door and front glass securely. 5. Pass wire ropes between the 1st and 2nd track rollers from the front and between the 1st and 2nd track rollers from the rear. For machines equipped with a full roller guard for the track roller, pass the wire rope under the track. 6.
Set the lifting angle of the wire rope to 30є to 40є, then lift the machine slowly. 7. After the machine comes off the ground, check carefully that the machine is balanced, then lift slowly. 2-126 PC400LC-7E0