OPERATION Remark When unloading the machine, always keep the arm and boom at an angle of 90 o - 110 o . If the machine is unloaded with the arm pulled in, it will cause damage to the machine. When moving onto the ramps, do not thrust the bucket into the ground. This will cause damage to the hydraulic cylinders. 12. When moving from the rear of the trailer on to the ramps, set the angle of the arm and boom to 90 Ч to 110 Ч , lower the bucket to the ground, then move the machine slowly. 13. When moving down the ramps, operate the boom and arm slowly to lower the machine carefully until it is completely off the ramps.
LIFTING THE MACHINE The operator carrying out the lifting operation using a crane must be a properly qualified crane operator. Never raise the machine with any worker on it. Always make sure that the wire rope is of ample strength for the weight of this machine. When lifting, keep the machine horizontal. When carrying out lifting operations, set the lock lever to the LOCK position to prevent the machine from moving unexpectedly. Never enter the area under or around a raised machine. Never try to lift the machine in any posture other than the posture given in the procedure below or using lifting equipment other than in the procedure below.
There is a hazard that the machine may lose its balance . Remark The lifting method differs according to the attachments and options installed. In such cases, please contact your Komatsu distributor for information. For details of the weight, see See “SPECIFICATIONS” on page 4-2. When lifting the machine, carry out the operation on flat ground as follows. PC400LC-7E0 2-125