OPERATION 3. Load and unload on firm level ground only. Maintain a safe distance from the edge of a road. 4. Apply the trailer brakes securely, then put blocks (1) under the tires to prevent the trailer from moving. Set left and right ramps (2) parallel to each other and equally spaced to the left and right of center (3) of the trailer. Set the angle of installation (4) a maximum of 15 o . If the ramps bend a large amount under the weight of the machine, put blocks under the ramps to prevent them from bending. 5. Remove the chains and wire ropes fastening the machine. 6. Start the engine. Warm the engine up fully. 7. Set the lock lever to FREE position (F). 8.
Turn the travel speed selector switch to low speed travel (Lo lamp lights up). Press travel speed selector switch (5) to set the travel speed. The travel speed ( Lo, Mi, Hi ) is displayed on monitor display (6). 9. Turn auto-deceleration switch (7) OFF and operate the fuel con- trol dial to set the engine speed to low idling. Each time auto-deceleration switch (7) is pressed, it switches OFF ON OFF in turn. When auto-deceleration switch (7) is turned OFF, display monitor (8) goes out. 10. Raise the work equipment, pull in the arm under the boom, then move the machine slowly. 11. When the machine is horizontal on top of the rear wheels of the trailer, stop the machine. 2-124 PC400LC-7E0