Komatsu — CHECK AND TIGHTEN TRACK SHOE BOLTS

MAINTENANCE For the cleaning, use only approved Komatsu Cooling System Flush, (Restore and Restore Plus by Fleet guard) follow the instruction on the flushing solution. 10. Close drain valve (6) and (7). 11. Install the covers (4) and (5). 12. Replace the corrosion resistor (8), then turn the valve fully to the left to open it. (Only machines equipped with corrosion resistor) 13. Add coolant mixed with antifreeze until it overflows from the water filler. Decide the proportions of antifreeze and water according to the table for the mixing rate of water and antifreeze.

Run the engine at low idling for 5 minutes to remove the air from the water, then run at high idling for 5 minutes.(Leave radiator cap (2) removed when doing this.) 14. Drain the coolant from sub-tank and clean the inside of the sub-tank, then add water until the coolant level is between the FULL and LOW marks. 15. Stop the engine, wait for approximately 3 minutes, then add cool- ant until the coolant level is near the coolant filler port, and tighten the cap. Check the coolant level and add coolant if neces- sary. CHECK AND TIGHTEN TRACK SHOE BOLTS If the machine is used with loose track shoe bolts (1), they will break, so tighten any loose bolts immediately. TIGHTENING TRACK SHOE BOLTS 1.

First tighten to a torque of 392 ± 39.2 Nm (289.3 ± 28.9 ft/lbs) then check to be sure the nut and shoe are in close contact with the link contact surface. 2. After checking, tighten further 120є ± 10є. ORDER FOR TIGHTENING Tighten the bolts in the order shown in the diagram on the right. After tightening, check to be sure the nut and shoe are in close contact with the link mating surface. 3-28 PC400LC-7E0