Komatsu — CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST

MAINTENANCE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING The deflection of the belt should be 14 to 16 mm (0.6 in) when pressed with a finger force of approximately 58.8N (13.2 lbs) at mid-point (a) between the crankshaft pulley and the compressor pulley. (A) Compressor pulley (B) Crankshaft pulley ADJUSTMENT 1. Remove guard (1). 2. Loosen bolt (2) and nut (3). 3. Turn nut (4) clockwise and move compressor (5) so that the deflection of the belt is approximately 14-16 mm (at a force of approximately 6 kg). 4. When the position of the compressor is determined, tighten nut (3) and bolt (2) to lock it in position.

Remark Check each pulley for damage, wear of the V-groove, and wear of the V-belt. In particular, be sure to check that the V-belt is not touching the bottom of the V-groove. In case any of the following occurs, ask the Komatsu distributor in your territory to replace the belts with new ones. The fan belt has elongated, leaving little allowance for adjustment. A cut or crack is found on the belt. Slipping or creaking sound is heard coming from the belt. When the new V-belt is set, readjust it after one hour of operation. 3-50 PC400LC-7E0