CLEAN/INSPECT RADIATOR, OIL COOLER, AFTERCOOLER AND CONDENSER FINS MAINTENANCE If compressed air, high-pressure water, or steam hit your body directly, or they cause dirt or dust to be blown up, there is a hazard of serious injury. Always use safety glasses, dust mask, or other protective equipment. Remark When using compressed air for cleaning, blow it keeping some distance to avoid damaging the fins. Damage on the fins can cause water leakage and overheating. In a dusty job site, check the fins every day, regardless of the maintenance interval. 1. Remove cover (1). 2. Loosen screw (2) and pull up net (3). 3. Clean net (3). (it is to be installed again, as instructed in the step 8.) 4.
Remove 5 bolts (4), then move bracket (5) to the side and make a gap between radiator fins (6) and oil cooler fins (7). 5. Inspect the front and rear of radiator fins (6), oil cooler fins (7), after-cooler fins (8) and condenser fins (9) for dirt, dust, dry leaves, etc. Blow them away with compressed air, if any. Steam or water may be used instead of compressed air. 6. Check the rubber hose. Replace with a new one if the hose is found to have cracks or to be hardened by aging. In addition, check the hose clamps for looseness. 7. Remove undercover (10) and blow the mud, dirt, and leaves that have been cleaned off to the outside. 8.
Push in cleaned net (3) back to the original place and secure it with screw (2). 9. Secure bracket (5) with bolt (4). 10. Remove the cover (1) and undercover(10). PC400LC-7E0 3-57