Komatsu — CHANGING ENGINE OIL AND REPLACING ENGINE OIL FILTER CARTRIDGE

MAINTENANCE CHANGING ENGINE OIL AND REPLACING ENGINE OIL FILTER CARTRIDGE Parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the oil temperature to go down before performing this operation. Refill capacity: 38 liters (10.04 US gal) Filter wrench 1. Remove cover (1) under the machine and put a container under drain valve (P) to catch the drained oil. 2. To prevent getting oil on yourself, lower the lever on drain valve (P) slowly, drain the oil, then raise the lever to close the valve. 3. Open the engine hood. Using a filter wrench remove filter (2). 4.

Clean the filter holder, fill the new filter cartridge with clean engine oil, coat the thread and packing surface of the new filter cartridge with clean engine oil (or coat it thinly with grease), then install it to the filter holder. Remark Check to be sure there is no old packing stuck to the filter holder. If there is any old packing stuck to the filter, it will cause leakage of oil. 5. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it a further 3/4 to 1 turn. 6. After replacing the filter cartridge, open the engine hood and add engine oil through oil filler (F) to between the (H) and (L) marks on dipstick (G). 7.

Run the engine at idling for a short time, then stop the engine and check again that the oil level is between the (H) and (L) marks on dipstick (G). 8. Install cover (1). 3-56 PC400LC-7E0