MAINTENANCE 7. Set the lock lever to the LOCK position, then turn the ignition switch to the OFF position. 8. Insert the lock pin in position (a) so that the attachment control pedal cannot be operated. (If equipped) CHECK ALTERNATOR, STARTING MOTOR The brushes may be worn or the bearing may have run out of grease, contact your Komatsu distributor for inspection and repairs. If the engine is started frequently, have this inspection carried out every 1000 hours. CHECK ENGINE VALVE CLEARANCE, ADJUST Special tools are needed for the inspection and maintenance, so please contact your Komatsu distributor to have this work carried out.
CHECK VIBRATION DAMPER Check to be sure there are no cracks or peeling in the outside surface of the rubber. If any cracks or peeling are found, contact your Komatsu distributor to have the parts replaced. 3-72 PC400LC-7E0