. OPERATION OPERATION CHECK OIL LEVEL IN ENGINE OIL PAN, ADD OIL WARNING engine is stopped and may cause serious burns. Wait for the oil 3. Fully insert dipstick (G) into filler pipe (F), then remove it. the 3 - 77 Parts and oil are a t high temperature immediate ly after the temperature to go down before performing this o peration. 1. Open the en gine side cover on the left side of the chassis 2. Remove dips tick (G), and wipe the oil o ff with a cloth. 4. The oil level should be between the H ENGINE ST If the oil leve OPPED side of dipstick (G l is below the L mark, add oil through oil f iller 5. If the oil is a bove the H mark, remove drain plug (1), drain valve ( again. 6.
If the oil leve 2) to drain the excess oil, t hen check the oil l close the en REMARK When checkin g the oil level after the en gine has been operated, wait for at least 15 min engine before checking. is at an angle make it horizontal before checking. If the machine is at an angle make it hor izontal before When adding oil, remove the dipstick for m the holder t o release the air inside the crank The dipstick is marked with the levels for "ENGINE STOPPED" on one side and "ENGIN side.
It is also poss · Check oil wh · Read the dip ible to check the oil level w ith the engine idling, but be sure to remember t en the engine coolant tem perature gaug e is stick on its reverse side m arked with "ENGINE