. OPERATION OPERATION on dipstick (G). The dipstick has STOP for use idling and the oil temperature is high. REMARK HOT IDLE. REMARK When inspecting, if the machine is at an angle, move it to a level place to carry out the check. 3 - 78 CHECK OIL LEVEL IN POWER TRAIN CASE, ADD 1. Remove dipstick ( G), and wipe the oil off with a cloth. 2. Fully insert dipstic k (G) into filler pipe (F), the n remov arks low the L mark, add oil thro wo sides for checking the hen the engine is stopp ugh oil f oil level ed and iller (F). : COLD the oil ; and HOT IDLE for use wh en the e ngin e is stopped starting operations, ch eck the oil level with the sid e marke d COLD STOP.
It is also possi ble to check the oil level ev en after starting operations when the p ower train oil temperature is high, but in this case, run th e engine at idling and use the side marked 4. If the oil is above t he H line, remove drain co ver (1) a t the left side at the bottom hose (2) from the t excess oil, then ch surface of the power train ca se, pull out d rain ake-out port, loosen drain p lug (3), d rain the eck the oil level again. p securely. 5. If the oil level is co rrect, tighten the oil filter ca