. OPERATION TRANSPORTATION TRANSPORTATION LOADING, UNLOADING WORK WARNING 3 - 134 When transporting the machine, observe all related laws and regulations, and be careful to a TRANSPORTATION PROC EDURE e, choose the optimum transportation method in reference to the weight and When transporting the machin dimensions shown in "SPECIFIC ATIONS (PAGE 5-2)". Note that machine sp ecifications (we ight and dimensions) vary depending on the kind of tr ack shoes and work equipment. porting the machine.
A t railer should be used for trans Make sure the ramp has sufficien t width, length and thickness to enable the machin e to be safely loa ded and unloaded If the ramp sags appreciably, rein When loading and unloading the machine, park the trailer on a flat firm roadbed. Kee p a fairly long di stance between th e road shoulder and the machine. arriage to prevent the machine from slipping to the side on slopes. and free of grease, oil, ice and loose materials. Remove the mud from the underc arriage to prevent the machine from slipping to th e side on slopes. Be sure the ramp surface is clean and free of grease, oil, ice and loose materials.
Never change the direction of trav el when on the ramps. If it is necessary to change direction, drive o ff the ramps and c orrect the direction, then drive on to the ramps again. When loading or unloading, alwa ys use ramps or a platform and carry out the operations as LOADING el ground only. m the edge of a road. 1. Load and unload on firm lev Maintain a safe distance fro 2. Apply the trailer brakes secu tires to prevent the trailer fro Set left and right ramps equally spaced to the left Make angle of installatio ramps bend a large a machine, put blocks unde bending. 1. Load and unload on firm lev 2. Apply the trailer brakes secu rely, then put blocks (1) under the m moving.
(2) parallel to each other and and right of center (3) of the trailer n (4) a maximum of 15°. If the mount under the weight of the r the ramps to prevent them from 3. Set parking brake lever to th e FREE position (F). 4. Set the transmission in the 1 st gear and run the engine at low idle. d the ramps and drive slowly. 5. Set the travel direction towar 6. The center of gravity of the machine shifts suddenly at the border between the ramps unbalanced and becomes d border slowly. and trailer, and the machine is angerous. Accordingly, pass the cified position on the trailer. 7. Stop the machine at the spe