Komatsu — REPLACE ADDITIONAL FUEL FILTER CARTRIDGE (IF EQUIPPED WITH MACHINES)

. MAINTENANCE SERVICE PROCEDURE REPLACE ADDITIONAL FUEL FILTER CARTRIDGE (IF EQUIPPED WITH MACHINES) WARNING Container to catch the oil Prepare a filter wrench 8. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. 4 - 61 After the engine has been ope rated, all parts are at high temperature, so do not repla ce the filter imme diately. Wai t for a ll parts to cool down before starting t he operation. side the engine fuel piping system when the engine is running.

High pressure is generated in side the engine fuel piping system when t he engine i When replacing the filter, wai t for at least 30 seconds after stopping th e engine to let the internal p ressure go down before replacing the filter. close. air bleed plug in the fuel filter head. It is still under pressure, so fuel may spurt out. Do not bring any fire or flame Be careful when opening the air bleed plug in the fuel filter head. It is s till under p ressure, so fuel m ay spurt out NOTICE Genuine Komatsu fuel filter c artridges use a special filter that has hig hly efficient filtering ability. When replacing t he filter cartridge, always use a genui ne Komatsu part.

The common rail fuel injectio n system used on this machine consists of more pre cise parts than th e conventional in jection pump and nozzle. If any part other than a genuin e Komatsu filter cartridge is used, dust or dirt may ge t in and cause pr oblems with the in jection system. Always avoid using substitute parts. When carrying out inspection or maintenance of the fuel system, pay m ore attentio n than normal to the entry of dirt. If dirt is stuck to any part, use fuel to wash it off completely. 1. Close the fuel valve. 2. Set the container to catch cartridge. 3. Using a filter wrench, tur remove it. 4.

After removing the filter the fuel under the additional fuel filter n filter cartridge counterclockwise to , remove transparent bowl (1) and inspect it. If there is any damage, replace it with a new part. 1) and remove seal (2). ean fuel or oil, then install it. 1) to new filter cartridge (3). (1 kgm , 7.2 lbft) 5. Clean transparent bowl ( Coat new seal (2) with cl 6. Install transparent bowl ( Tightening torque: 10 Nm 7. Check that drain plug (4) at the bottom of the transparent bowl is tightened securely. Tightening torque: 0.2 to 0.3 lbf 0.45 Nm (0.02 to 0.046 kgm , 0.1 to t)