Komatsu — REPLACE ADDITIONAL FUEL FILTER CARTRIDGE (IF EQUIPPED WITH MACHINES)

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE 4 - 62 When addin g fuel, do no t remove cap (B). Always add small holes ( A) on the dir ty side. After a dding fuel, remove cap (B) and install the fuel fil Alway s fill w ith clean fue l. Be careful not to let any dirt the fu el. In p articular, cen ter portion is the clean side, s cap (B ) when adding fuel. Be careful not to let dirt or dus portio n on th e clean side 9. Whe n installing, tight en until the packing surface contacts the seal surface of the filter h older, t hen tighten it 3/4 of a turn. If th e filter cartridge is tightened too far, the pac king will be damaged and this wi ll lead t o leakage of fuel.

If the filter cartridge is too l oose, fuel will also leak fro m the packing, so always tighte n the co rrect a W hen t ightening w ith a filter wrench, be extre mely careful not to dent o r damage the filter. 10. Whe n carrying out sta ndard replacement of the f uel filter cartridge (every 1 000 hours), re place the cartridg e and blee d the air. For d etails, see "REPLACE F (MACHINES WITH ADDITIONAL FUEL FILTER CARTRIDGE) (PA 11. Ope n the fuel valve, start the engine, check that there is no leakage of fue l from the filte r seal surface or water separator mounting s urface, then run for approx . 10 minutes at low idling.