. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE NOTICE then tighten it. 10. After replacing the filter cartridge, start the engine and check for leakage from the filter seal surface. 4 - 64 Do not fill the fuel filter cartridge Remove cap (B) and install the fu 5. Clean the filter holder, coat th e packing surface of the new filter cartridge thinly with oil, then in stall the filter cartridge to the filter holder. 6. When installing, tighten until seal surface of the filter hold the packing surface contacts the er, then tighten it 3/4 of a turn. If the filter cartridge is tighte ned too far, the packing will be to leakage of fuel.
If the filter damaged and this will lead cartridge is too loose, fuel w ill also leak from the packing, so ount. always tighten the correct am 7. Open valve (1) of fuel straine r and loosen air bleeding plug (3). 8. Loosen the knob of primimg pump (4), move it up and down, 9. and continue until no more bu air bleed plug (3). Tighten air bleed plug (3), pus bbles come out with the fuel from h in the knob of priming pump (4), REMARK When only the filter cartridge is replaced, it is suffficient that air bleeding is carried out for the filt er head alone. But when the fuel piping is removed, air bleeding s hould also be carried out for the . injection pump air-bleeding valve