Komatsu — CHECK TIGHTENING PARTS OF TURBOCHARGER

. MAINTENANCE SERVICE PROCEDURE REPLACE MAIN CORROSION RESISTOR CARTRIDGE AND SUB CORROSION RESISTOR CARTRIDGE WARNING be 4 - 68 If the engine has been opera ted, all parts will be at a high temperature , so never tr y to replace the cart ridge immediately after stopping the engine. Always wait for the engine an Container to catch drain Prepare a filter wrench 1. Turn valve (3) of main corrosion resistor (1) and sub corrosi resistor (2) to the Clos e stopper position. h the coolant under the cartridge. 2. Set a container to catc 3. Using a filter wrench, t urn cartridge (4) to the left to remove 4. Clean the filter holder, coat the packing surface and thread the new cartridge with 5.

When installing, tighte oil, then install it to the filter holder. n until the packing surface contacts t seal surface of the filte If the filter cartridge is damaged and this will If the filter cartridge is t packing, so always tig r holder, then tighten it up 2/3 of tightened too far, the packing lead to leakage of coolant oo loose, coolant will also lea k from t hten to the correct amount . position. check for a 6. Turn valve (3) of cartri 7. After replacing the cart dge to the OPEN stopper ridge, start the engine and coolant leakage from leakage, check if the c the filter seal surface. If there is a artridge is tightened properly.

CHECK TIGHTENING PAR TS OF TURBOCHARGER Contact your Komatsu dis tributor to have the tightening portion s checked.