Kenworth — Kenworth T170 T270 T370 and Hybrid 2011 Body Builders Manual

Section 8 Electrical Table 8-5. Switch and Wiring for Customer Installed Beacon Lamp. * Fuse F28 requires “Spare Accessory” relay K5. ** Beacon Lamp Switch is located in dash area 4 and use a lighted rocker switch P27-1127-011. *** Beacon Lamp Switch is wired to both a 2-way Packard Weatherpack connector in the cab behind dash area 2 (LH Gauge Panel) and **** wired to the 6-way Packard connector on LH Frame rail Back of Cab near 9-way Trailer/body connector. (Both switched power and ground is provided in the cab and chassis connectors). Fuse F28 will accept an optional Polyswitch for circuit protection. Optional Switch Panel Harness (P92-4122-1xxxxx) is used for Beacon Lamp Switch.

Figure 8-18. Switch and Wiring for Customer Installed Flood Lamp. Chassis Harness. Sales Code 9058037. Location: LH Rail Approx 400mm Back of Cab. Table 8-6. Switch and Wiring for Customer Installed Flood Lamp. ** Flood Lamp Switch is located in dash area 4 and use a lighted rocker switch P27-1127-002. *** Flood Lamp Switch is wired to a 2-way Packard Metripack connector on LH Frame rail Back of Cab near 9-way Trailer/body connector. )Both switched power and ground is provided in the chassis connector).

8-22 12/11 Fuse Fuse size Buss Fuse Description Switch Connector Description** Cab Connector Description*** Chassis Connector Description**** Chassis Connector Terminal F28* 15A Spare ACC Beacon Lamp J13, Beacon Lamp SW P018, Beacon Lamp P764, Spare Circuits C Fuse Fuse size Buss Fuse Description Switch Connector Description** Chassis Connector Description*** Chassis Connector Terminal F53 15A Batt 2nd Flood Lamp J19, 2nd Flood Lamp SW P7641, 2nd Flood Lamp B