Section 8 Electrical ADDITIONAL SPARE CIRCUITS If you just need spare power, wire into one of the spare circuits we provide. WARNING! Do not install an electrical circuit that requires more amperage (electrical capacity) than what is available in the specific chassis circuit. An overloaded circuit could cause a fire. Compare the amperage requirements of the new circuit to the electrical current capacity of the existing chassis circuit before adding the body or other equipment. When adding an electrical circuit, you must know the current capacity (amperes) of each circuit. The capacity of the existing system in the chassis must be enough to power the additional circuit.
The new circuit will re- quire a certain amount of power to operate; so, the existing (battery or alternator) power source must have the capacity to provide additional power or the new circuit will not function properly. Check the current (ampere) demand of the circuit to be added. Compare it to the current capacity of the circuit you are connecting into. The current carrying capacity of the wires, controls, switches, and circuit breakers that provide current to the circuit must be equal to or greater than the demand of the added circuit otherwise these components may not work properly. See Table 8-7 for relevant circuit information.
Additional Spare Circuits for Wiring Depending on options ordered for the truck, there may be up to five spare circuits with labeled connectors available in the dash harness. See Table 8-7 for circuit information, circuit CAPACITY, connector breakout locations and location to install fuses in fuse panel. For unused spare circuits, since these are separate circuits; you will not affect existing circuits in the chassis by connecting to them. They include: 3 spare battery circuits 2 spare ignition circuits Note: Some spare circuits may be used with factory installed options. For specific chassis questions please work with your Kenworth Dealer. Table 8-7. Additional Spare Circuits for Wiring.
8-23 12/11 Spare Circuit Powered Through Label on Connector Minimum Wire Gauge Dash Harness Connector Behind Dash Panel 4 Circuit Wire Color Capacity (Amperes). Install a fuse of ap- propriate rating Numbered Loca- tion on fuse panel behind dash Ignition Spare IGN 1; 15 amps 14 ORN1221-0 Orange 15 F81 Ignition Spare IGN 2; 15 amps 14 ORN1222-0 Orange 15 F80 Battery Spare Batt 1; 15 amps 14 RED1211-0 Red 15 F49 Battery Spare Batt 2; 15 amps 14 RED1212-0 Red 15 F50 Battery Spare Batt 3; 20 amps 12 RED1213-0 Red 20 F29