Section 8 Electrical Hybrid Utility Connector Hybrid utility trucks come equipped with a utility connector to interface with the body builder’s body controller. The breakout for the utility connector is 3000mm long and can be located, bundled up, by the transmission (see Figure 8-22). The length of the body builder’s mating harness must not exceed 2500mm. Pins 7 and 8 are J1939 communication lines and must be a twisted, shielded, jacketed pair of wires. Pin 6 is the drain wire for the shield. Pins 1&2 Pins 1&2 are part of a Park Brake and Hood Switch interlock circuit.
A ground signal is applied to pin 1 and with both the hood closed and the park brake applied the circuit will be completed and a signal will appear on pin 2. Pin 3 Pin 3 is Battery Power and is rated for 10 Amps. The fuse is located inside the Vehicle Electronics Carrier (VEC) in position F6. Pin 3 is live at key on. Pin 4 Not Used. Pin 5 Pin 5 is Ground. Pin 6 Pin 6 is the drain wire for the J1939 CAN line. The drain wire must only be connected to Pin 6. Do not connect the other end of the drain wire. Pin 7&8 Pins 7&8 are J1939-11 Vehicle CAN (VCAN) lines. Pin 7 is LOW and Pin 8 is HIGH. 8-27 12/11