Komatsu — CHECKING AXLE OIL LEVEL, ADD OIL

MAINTENANCE CHECKING AXLE OIL LEVEL, ADD OIL When checking the oil level, apply the parking brake and secure the front and rear frames with the safety bar. After stopping the engine, the parts and oil are at a high temperature. Wait for the temperature to go down before starting the operation. Carry out this procedure if there is any sign of oil loss on the axle case. Carry out the inspection with the machine on a horizontal road surface. (If the road surface is at an angle, the oil level cannot be checked correctly.) A : Front B : Rear 1. Stop the engine and remove the mud and dirt from around plug (1), then remove the plug (1). 2.

Wipe off any oil adhering to the oil level gauge attached to plug (1) with cloth. 3. Use the oil level gauge (G) as shown in the right diagram. 4. The oil level is correct when it is between the two lines provided on the oil level gauge. If the oil level does not reach the lower line, add axle oil through filler port (F). 5. If the oil level is above the upper line, drain off the excess oil through drain plug (P) and check the oil level again. 6. If the oil level is correct, install plug (1). Tightening torque: 93 to 123 Nm 9.5 to 12.5 kgfІm, (68.7 to 90.4 ft/lbs) WA320PT-5L 3-21