MAINTENANCE EVERY 2000 HOURS SERVICE Maintenance for every 50, 100, 250, 500 and 1000 hours service should be carried out at the same time. CHANGING HYDRAULIC OIL AND FILTER ELEMENT The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. Refill capacity: 89 liters (25.51 US gal) 1. Lower the bucket horizontally to the ground and apply the parking brake, then stop the engine. 2. Remove covers (1) and (2). 3. Keep grip (3) pulled, then turn oil filler cap (F) counterclockwise and remove it. 4.
Set a container to catch the oil under drain plug (P). 5. After removing drain plug (P), open drain valve (4) and drain the oil. 6. After draining the oil, close drain valve (4) and install drain plug (P). 7. Using a filter wrench, turn cartridge (5) to the left to remove it. 8. Clean the filter holder, fill the new filter cartridge with oil, then coat the seal and thread of the filter cartridge with oil (or coat thinly with grease) and install. When installing the seal, tighten it until its surface comes to contact with the filter holder, then tighten it 1/3 turn more. 9. Refill the specified quantity of oil through oil filler (F). 10. Check that the hydraulic oil is at the specified level.
For details, See “CHECKING OIL LEVEL IN HYDRAULIC TANK” see page (3-32). 11. Run the engine at low idling, and extend and retract the steering, bucket, and lift arm cylinders 4 to 5 times. Be careful not to operate the cylinder to the end of its stroke (stop approx.100 mm (3.9 in) before the end of stroke). Remark If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder will cause damage to the piston packing. 12. Next, operate the steering, bucket, and lift arm cylinders to the end of their stroke 3 to 4 times, then stop the engine and loosen filler cap to bleed the air from the hydraulic tank. 13.
Check that the hydraulic oil level and add oil to the specified level. For details, See “CHECKING OIL LEVEL IN HYDRAULIC TANK” on page (3-32). 14. Next, raise the engine speed and follow the procedure in Step 12 to bleed the air. Repeat this process until no more air comes out. 15. After completing the air bleed operation, install cover (1) and (2). 3-44 WA320PT-5L