MAINTENANCE REPLACING HYDRAULIC TANK BREATHER ELEMENT The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. 1. Remove cover (1). 2. Loosen bolt (2) at the top of the filler cap, then remove cap cover (3). 3. Remove element (4). 4. Coat O-ring (5) of the new element with grease, then install. 5. Align cap cover (3) with the grooves in the body, then tighten with bolt (2). 6. Install cover (1). CHANGING AXLE OIL Refill capacity (front and rear, each): 24.0 liters (6.34 US gal) A : Front B : Rear 1.
Place a container to catch the oil under drain plug (P). 2. Remove plug (1), then remove drain plug (P) to drain the oil. Remove the mud and dirt from around plug (1), then 3. remove the plug. 4. After draining the oil, clean drain plug (P) and install it again. 5. Add axle oil through plug hole (1) at the refill level. Remark For axles with ASD (Limited-Slip Differential), the brand of lubricating oil is different, always use the specified lubricating oil. For operations where the brake is used frequently, change the axle oil at shorter intervals. 6. After adding oil, check that the oil is at the specified level. For details, See “CHECKING AXLE OIL LEVEL” on page (3-23). WA320PT-5L 3-45