OPTIONAL ATTACHMENTS USING LOADER WORK EQUIPMENT Lift arm control lever (1) and bucket control lever (2) can be used to operate the lift arm and bucket as follows. Basic Precautions When using the loader for any loading, digging or grading operations avoid any wheel slippage, this will damage the tires. Keep in mind the higher you go with the bucket loaded or unloaded the higher you will force the center of gravity on the machine. Doing so makes the machine less stable. Never use the float feature when traveling forward with the machine. Never use the float feature to lower the bucket. Never raise the boom with the bucket fully loaded and the machine articulated.
There is danger that the machine may tip over. When the machine is traveling or the work equipment is raised, the activation of the E.C.S.S. switch (if equipped) will cause the work equipment to move. If operations are carried out with the E.C.S.S. switch (if equipped) in the ON position, and the travel damper switch is turned ON, the work equipment will move. LOADING PILED SOIL OR BLASTED ROCK When loading piled soil or blasted rock, operate the machine as follows. To prevent cutting the tires caused by the tire slipping, be aware of the following points during the operation. Always keep the operating job site flat, and remove any fallen rocks.
When working with stockpiles, operate the machine in 1st or 2nd speed range; when loading blasted rock operate the machine in 1st speed range. When performing loading operations always keep the machine frame angle perpendicular to the load. Never load the bucket with the machine frame articulated. Never use the steering to break out material. Avoid stalling the hydraulics when performing loading operations. Always maintain a continuous motion. 1. Stop with the bucket about 30 cm (12 in) from the ground, then lower it slowly to the ground. 2. Shift down to the lower speed ranges.
When completing the down shift, fully depress the left brake pedal and at the same time using the accelerator pedal increase the engine RPM. WA320PT-5L 5-3