The lift arm moves freely under external force. 5. Position (e): TILT OPTIONAL ATTACHMENTS When the work equipment control lever is pulled further beyond the TILT position, the lever is stopped in this position until the bucket reaches the preset position of the positioner, and the lever is returned to the HOLD position. 6. Position (f): DUMP DIRECTIONAL SELECTOR SWITCH This switch (2) is used to switch the direction of travel of the machine between forward and reverse. F Position: FORWARD N Position: NEUTRAL R Position: REVERSE Before operating this switch, check that the condition is as follows.
Directional lever is at N Directional selector switch actuation switch is at ON If the condition is not as above, the switch will not work. Remark When directional selector switch operation switch (3) is ON, if directional lever (5) is not at the N position and directional selector switch (2) is also not at the N position, the engine will not start. DIRECTIONAL SELECTOR ACTUATION SWITCH When this switch (3) is turned on, the directional selector switch is actuated. Position (a): ON The directional selector switch is actuated. Position (b): OFF The directional selector switch is turned off.
Remark Turn this switch ON when the directional lever and directional selector switch are at the neutral position. At any other position, this switch does not work. Even if the directional selector switch is functioning, when the directional lever is operated, the operation of the directional lever is given priority. WA320PT-5L 5-9