SWITCHES OPERATION Manual switch controlled systems are used to operate electrically operated features. Most of these features are not part of the controls in the main operating system. However, it is important that the operator know where they are located and how they operate. IGNITION SWITCH Switch (1) is used to start or stop the engine. OFF position: In this position, you can insert or remove the key. All the electrical systems are off, and the engine will stop. ON position: In this position, electrical current is now connected to the circuitry, and all accessory operate. Always keep the ignition switch in the “ON” position while operating the machine. START position:
This position is used to start the engine. Hold the key in this position while cranking the engine. Release the key immediately after the engine has started. The key will return to the ON position when released. SPEED RANGE SELECTOR SWITCH Switch (2) is used to select the speed ranges. Use setting1st and 2nd for loader operations, and 3rd and 4th for travel. Position (a): 1st Position (b): 2nd Position (c): 3rd Position (d): 4th VARIABLE SHIFT CONTROL SWITCH When the speed range is in 1st, it is possible to use this dial (3) to set the maximum speed as desired. Turn the dial to the right to increase the setting; turn it to the left to decrease the setting.
Keep in mind conditions for use may differ according to the condition of the road surface. WA320PT-5L 2-23 Factory Tire Size Max. Speed km/h (MPH) Standard tire (20.2-25) 4.0 - 13.0 (2.5 - 8.1)