Komatsu — ECSS SWITCH

OPERATION TRACTION CONTROL SWITCH Switch (4) can be used to actuate the traction control and reduce the maximum rim pull. Position (a): ON Traction control is activated Position (b): OFF Traction control is deactivated Remark Traction control is effective in preventing the tires from slipping during light-duty operations. ECSS SWITCH The ECSS. is a device that uses the hydraulic spring effect of an accumulator to absorb the vibrations of the chassis during travel. This allows the machine to travel smoothly and at high speed. If the machine is traveling with the work equipment raised, and the E.C.S.S. switch is suddenly turned ON, the work equipment will move.

If operations are carried out and the E.C.S.S. switch in the ON position, changing the E.C.S.S. switch to the OFF position may cause the work equipment may move. Never turn the E.C.S.S. switch ON during inspections or maintenance. The work equipment will move and create a dangerous situation. Remark Always stop the machine and lower the work equipment to the ground before using the ECSS system. When carrying out inspections and maintenance, first lower the work equipment to the ground, then turn the ECSS switch OFF before starting any of these inspections and maintenance procedures. When carrying out leveling operations, turn the E.C.S.S. switch OFF. Switch (5) is used to turn the E.C.S.S.

ON and OFF . Position (a): ON The pilot lamp (A) lights up and the E.C.S.S. is actuated. Position (b): OFF The ECSS. is not actuated. Remark The travel damper is automatically actuated when the travel speed is higher than 6 km/h (3.7 MPH); when the travel speed drops below 5 km/h (3.1 MPH) it is automatically disengaged (when 20.5-25 tires are used). 2-24 WA320PT-5L