OPERATION MODE SELECTOR SWITCH Switch (3) is used to select the vents. The following five vent modes are available: FACE, FACE/ FOOT, FOOT, FOOT/DEF, DEF. When the switch is pressed, the indicator lamp above the switch lights up to display the vent mode. (FRESH/RECIRC) SELECTOR SWITCH Switch (4) is used to select between recirculation of the air inside the cab or intake of fresh air from the outside. When the switch is pressed, indicator lamp (A) at the top of the switch lights up. Recirculation of air inside cab: Press switch (B) to use only the air inside the cab. Use this position for rapid heating or cooling or when the outside air is dirty. Intake of fresh air from outside:
Press this switch (C) to carry out heating or cooling with fresh air from the outside. Use this position when removing mist from the cab windows. TEMPERATURE CONTROL SWITCH The temperature can be adjusted with switch (5) by pressing and holding the up or down button. The temperature level indicator lamps (A) light up to display the temperature of the air coming from the vents. The more blue the lamps are, the lower the temperature is. The color of the indicator lamp (A) changes while the switch is being pressed. When the temperature reaches the desired level, release the switch to set the temperature.
The settings for each mode are retained in memory even when the ignition switch is turned OFF. However, in the following cases, the settings must be adjusted again. When the machine has been out of use for more than 7 days When the battery voltage is extremely low When there has been interference from outside When the fan switch is turned OFF (the setting is not kept in memory with only the air conditioner switch) If the air conditioner is used in the FRESH position, the inside of the cab will be pressurized, this will prevent the entry of dust. The higher the position of the fan switch, the more effective the pressurizing becomes. 2-42 WA320PT-5L