MAINTENANCE SECTION 5 Page 25 5.8. COOLING SYSTEM Installation When installing the cap, gasket and contacting surfaces must be clean. Turn the cap to the right or clockwise until snug. 5.8.5. CHECKING COOLANT LEVEL Check the coolant level before starting the engine. 1. Check the coolant level daily to be sure that level is proper. Coolant level must be seen in the inspection hole (3) Fig. 5.8. 2. For checking the coolant level place the machine on the level ground and lower the mounted equipment on the ground. 3. If coolant has to be added, remove radiator cap and pour the coolant until it will be visible in the inspection hole.
After replenishing coolant in the radiator check and correct concentration of DCA4, and check freezing point in winter time. 5.8.6. CLEANING THE RADIATOR CORE Every 50 hours of operation remove dirt from the radiator core blowing it through with compressed air in the direction opposite to fan. 5.8.7. ADDING THE COOLANT WHEN ENGINE IS HOT IMPORTANT: Never add coolant when engine is hot. This may result in damage to the engine. Allow the engine to cool down below 50°C prior to replenishing coolant in the radiator. 5.8.8.CHANGING COOLANT 5.8.8.1. Draining the System 1. Run the engine until it reaches operating temperature, then stop the engine. Fig. 5.9 Drain Valve of Water Cooler.
DRESSTA TD-20H