MAINTENANCE SECTION 5 Page 35 5.12. FUEL SYSTEM NOTE: Water contaminated with sediment and fuels as well as oil are detrimental to environment. Drain water to suitable container and utilize in appropriate area. 5.12.4.2. Replacing the Fuel Filter Replace fuel filter when the engine is misfiring, loss of power is evident or after 250 hours. Keep the new filter in the original package until ready for installation. Before loosening the filter, clean the filter head to prevent dirt or foreign material from entering the system. 1. Close the fuel shutoff valve under the fuel tank. 2. Remove the fuel filters from the filter header using a filter removal wrench. 3.
Thoroughly clean the filter header to prevent dirt or foreign material from entering the system. 4. Fill fuel filter with clean fuel. 5. Apply a light coating of clean engine oil to the seal surface on the new filter. 6. Install the new filter, turning it until the seal just contacts the filter head and tighten the filter an additional 1/2 to 3/4 turn. NOTE: Thread the filters by hand. Do not use any tools to install the filters because this can damage the filter. NOTE: Use only recommended filters available from Authorized Distributor of Construction Equipment. 5.12.5. DRAINING FUEL TANK Fig. 5.20.
Fuel Tank Drain Valve Periodically open the valve and drain water and sediment from the fuel tank until clean diesel fuel appears. Close the valve. 5.13. HYDRAULIC SYSTEM General WARNING! Always lower all mounted equipment to the ground before performing work on the hydraulic system. With all mounted equipment lowered to the ground and the engine off, cycle all hydraulic controls in all directions to relieve trapped pressure. Slowly loosen the hydraulic reservoir filler cap to relieve trapped reservoir pressure. DRESSTA TD-20H