DRESSTA TD20H98/1E — 5.13.2. CHANGING HYDRAULIC OIL

SECTION 5 MAINTENANCE Page 36 5.13. HYDRAULIC SYSTEM 5.13.1. CHECKING OIL LEVEL 1. Park the machine on level ground lower the blade and the ripper to the ground and stop the engine. 2. Check oil level at sight gauge on the side of the reservoir. Add oil if level is below the center line of the gauge. Refer to „OIL CHANGE”. Fig. 5.21. Hydraulic Reservoir Sight Gauge NOTE: Before removing any components from the reservoir or servicing, wipe the top surface of the reservoir, using clean kerosene or a commercial cleaning solvent. 5.13.2. CHANGING HYDRAULIC OIL 1. Start the engine and operate the blade to warm the oil for easy draining. 2.

Park the machine on level ground, lower the blade and the ripper to the ground. 3. Stop the engine. Shift to neutral and apply the neutral lock lever. Apply and lock the parking brake. Turn the electrical system master switch to OFF and remove the key. Slowly loosen reservoir filler plug to relieve reservoir pressure. 4. Drain the reservoir into a suitable container by removing the filler plug and the drain plug 5. Replace return filter of hydraulic system and equipment hydraulic control circuit filter. Refer to „SERVICING THE RETURN FILTER”. Service the suction strainer as described under „SERVICING THE SUCTION STRAINER”. Service hydraulic reservoir filler strainer. TD-20H DRESSTA