MAINTENANCE SECTION 5 Page 59 5.19. UNDERCARRIAGE 5.19.6. PIVOT SHAFT Fig. 5.49.Track Frame Oil Filler Plug Remove the plug (one at each side), check oil level and if the lubricant is low, fill to the level of the plug opening. Reinstall and tighten the plug. NOTE: Refer to the „REFILL SPECIFICATIONS AND CAPACITIES” chart for grade of lubricant specified. 5.19.7. EQUALIZER BAR Periodically check the condition of wear pads that support equalizer bar ends in track frame rebound brackets. The distance (A) between equalizer bar (3) and rebound bracket (1) is to be measured periodically too. Perform measurement when both track frames are leveled.
Add or remove such a number of shims (2) to obtain distance of 4.8 - 6.3 mm. Replace pads if any cracks are found. Fig. 5.50. Rebound Gap of the Equalizer Bar 1. Rebound bracket 2. Shims 3. Equalizing Bar 4. Pad DRESSTA TD-20H