SECTION 5 MAINTENANCE Page 60 5.19. UNDERCARRIAGE 5.19.8. FRONT WHEEL Periodically check the thickness of front wheel guides. (4 off in the right track frame and 4 off in the left track frame). If they are weared (min. thickness is 16 mm) replace them. Fig. 5.51. Idle Wheel Guides 1. Minimum thickness 16 mm. 2. Guides 5.20. ADJUSTING HAND AND FOOT CONTROLS Check engine high and deceleration RPM. If RPM values are incorrect proceed as follows: Check adjustment of hand levers and foot pedals per below given drawing. a) Adjust lever „4” to vertical position of the lever for high idle speed (2300 RPM) During the adjustment the lever „1” must be placed in its foremost position.
b) Adjust lever „2” to maintain the dimension 200 mm and 36 mm. c) Adjust foot pedal „3” to maintain the dimensions in mm (Refer to Fig. 5.52): I - Engine high speed position (2300 ± 100RPM) II - End of deceleration (1100 ± 50 RPM) III - Beginning of braking IV - Full brake After adjustment made lubricate linkage and fill bearings with grease through lubrication fittings (refer to „LUBRCATION FITTINGS”) and check if the machine is stopped with applied Decelerator–Brake pedal (Refer to 3.3. for brake operation principle). Perform brake test as follows:
– start the engine and bring transmission system to operating temperature – shift to 2nd speed with engine at top speed and brake the machine for a while With correct adjustment made the machine should stop. If in doubt contact Authorized Distributor of Construction Equipment. TD-20H DRESSTA