SECTION 6 SPECIFICATIONS Page 21 6.8.
SPECIAL TORQUES Torque tolerances ± 10% *) - tighten with LOCTITE 262 **) - cover the thread and face under the bolt head with engine oil - torque 400 ± 70 Nm + tightening by the angle of 120 0 TD-20H DRESSTA 76 Track roller shield plate bolt 3/4” 455 10 77 Sprocket rock deflector mounting bolt 3/4” 455 32 78 Equalizer bar pin retainer plate bolt 3/4” 455 8 79 Front idler shaft support bolt 7/8” 730 4 80 Final drive cover mounting bolt (to frame) 7/8” 735 20 81 Final drive planet carrier mounting bolt 7/8” 610 18 82 Diagonal strut cap nut (front blade) 3/4” 450 4 83 Vertical strut cap nut (diagonal blade) 3/4” 450 4 84 Cylinder yoke bolt (front blade) 3/4” 450 8 85 Cylinder yoke bolt (diagonal blade) 3/4” 450 8 86 Front and rear track idler mounting block bolts 7/8” 735 16 87 Rear frame drain plug 7/8” 48 - 32 3 88 Push arm trunnion cap bolt (front blade) 1” 1050 4 89 C-frame trunnion cap bolt (front blade) 1” 1050 4 90 Vertical strut cap bolt (front blade) 1” 1050 8 91 Diagonal strut cap bolt (front blade) 1” 1050 8 92 Transmission mounting bolt 1” 920 1 93 Transmission mounting bolt 1” 920 2 94 Counterweight drawbar mounting bolt 1” 920 1 95 Track frame guide plate mounting bolt 1” 1110 8 96 Track frame guide retainer bolt 1” 1110 8 97 Ripper mounting frame bolts 1-1/4” 1800 14 98 Rigid drawbar mounting bolt 1-1/4” 2190 8 99 Pivot shaft lock pin retainer plug 1-3/4” 275 2 100 Pivot trunnion bolt 1” 1050 16