SPECIFICATIONS SECTION 6 Page 22 6.9. STANDARD METRIC FASTENERS This chart provides tightening torque for general-purpose applications using original equipment standard hardware. Original equipment standard hardware is defined as coarse thread metric class 10.9 bolts and class 10.0 nuts and thru hardened flat washers (Rockwell "C" 38-45), all phosphate coated and assembled without supplemental lubrication (as received) condition. The torques shown below apply to phosphate coated bolts designed for 60% yield strength.
The torques shown below also apply to phosphate coated bolts used with phosphate coated prevailing torque nuts, phosphate coated bolts used with copper plated weld nuts and are applied to the steel and cast iron parts. NOMINAL THREAD DIAMETER (mm) STANDARD TORQUE ± 10% (Nm) 6 7 8 10 12 14 16 18 20 22 24 27 30 33 36 10 16 23 46 80 125 200 275 385 530 670 980 1330 1790 2325 6.10. TORQUE VALUES FOR STANDARD ENGLISH FASTENERS This chart provides tightening torque for general purpose applications using original equipment standard hardware as listed in the Parts Catalog for the machine involved. DO NOT SUBSTITUTE.
Original equipment standard hardware is defined as Type 8, coarse thread bolts and nuts and thru hardened flat washers (Rockwell "C" 38-45), all phosphate coated and assembled without supplemental lubrication (as received) condition. Phosphate coated bolts used in tapped holes in steel or gray iron. 2. Phosphate coated bolts used with phosphate coated prevailing torque nuts (nuts with distorted threads or plastic inserts). Phosphate coated bolts used with copper plated weld nuts. Markings on bolt heads or nuts indicate material grade ONLY and are NOT to be used to determine required torque. DRESSTA TD-20H