DRESSTA TD20H98/1E — 4.3. INSTRUMENT PANEL

SECTION 4 OPERATING Page 8 4.3. INSTRUMENT PANEL 10. TRANSMISSION SYSTEM OIL TEMPERATURE GAUGE This gauge shows the temperature of oil in transmission system. The pointer of the gauge must be in the GREEN area of the gauge. 11. VOLTMETER The voltmeter indicates the condition of the batteries. At low idle speed, the gauge pointer should be within the green with white stripe area, which indicates a good battery charge. If the voltage drops below this area, the batteries should be checked. With the engine operating above low idle speed, the pointer should be within the upper green area, which is the normal operating range.

If the pointer drops below or exceeds this area, the battery, alternator or wiring may be at fault. 12. LOW ENGINE COOLANT AND LOW OIL PRESSURE ALARM This alarm will sound when lubricating engine oil pressure or coolant level in radiator drops below normal. If so, stop the machine and find out which warning light glows and check gauge indication. 13. HOURMETER The hourmeter electrically records the actual hours of engine operation. The purpose of the hourmeter is to indicate when to perform the recommended maintenance and lubrication operations. The hourmeter will register only when the engine is running. 14.

START SWITCH BUTTON AND WARNING LIGHTS CHECK The button is used to crank the engine. Place the transmission neutral lock in neutral and the transmission electrical system master switch to the ON position. IMPORTANT: To prevent damage to the starter motor and avoid low battery output, do not continuously crank the engine for more then 30 second intervals. Allow 2 to 3 minute recovery period between cranking. Prior to starting the engine move the engine speed and shut down lever fully forward (OFF position), depress the starting switch and check if all warning lights glow. If any warning light doesn’t glow that indicates that the bulb is defective or its circuit is broken. 15.

LIGHTS SWITCH The work light switch is a rocker type switch. Activation of the switches turns on front and/or rear work lights. 16. ETHER INJECTOR SWITCH This switch controls the ether injector for cold weather starting. Refer to “STARTING THE ENGINE” for proper operation of this switch. 17. BRAKE LOCK This handle locks the brake pedal in the applied position for parking the machine. To lock the brake pedal, fully depress the pedal, pull out the lock handle and remove your foot from the pedal. To release the brake, simultaneously depress the brake pedal and push in the lock handle. TD-20H DRESSTA